Rapid Install System
Manual Systems
Installation Tools

Air Powered Belt Cutters

Air powered belt cutters are lightweight and easy to handle. They are capable of cutting through rubber and PVC up to 1½” thick. Included with the purchase of an air powered belt cutter is a laser guide (batteries included), a belt marking pen, a sharpening stone, two hex key wrenches, a laser screwdriver, SL-8 spray lubricant, instructions, and a convenient tote bag (not shown). Additional 1½” capacity blades may be purchased separately.

Number
APC-1.5
APC-1.5 BLADE
Air Powered Conveyor Belt Cutters.

Skiver/Cutter

This new and innovative tool will skive your belt to the exact required dimensions and cut it, all in one setup. Typical belt splice preparation is required. edge Stops are located on both sides of the tool to center the belt.

Number
SKCU-36
SKCU-48
SKCU-54
SKCU-60
SKCU-72
SKCU-84
Conveyor Belt Skiver / Cutter.

Skiver/Cutter Extra Supplies

NumberDescription
SKCU-CBK1Cutter Blade Kit
SKCU-SBK1Skiver Blade Kit
SKCU-RATRatchet
SKCU-FK1Diamond File Kit

Five-Prong Driver Rivet Punch with Safety Knob

The Five-Prong Driver drives five rivets at a time, but requires a 4 to 5 lbs. hammer. Rivets must be set after removal of the driver guides. For use with Guide Blocks, single- or double-wide.

Number
RNMDP-5
Riv-Nail five-prong driver rivet punch with safety knob from Conveyor Accessories

Single Driver Punch with Cushion Grip

The Single Driver Punch with Cushion Grip is an amazing tool for driving rivets one at a time. Safe, easy, and accurate placement of the rivets in two to three blows can be done by a novice — and completely sets the rivet! For use with Guide Blocks, single- or double-wide.

Number
RNSDP-1
Riv-Nail single driver punch with cushion grip installation tool from Conveyor Accessories is an amazing tool for driving rivets one at a time.

4 LBS. Hammer

14″ fiberglass handle for use with rivet punches

Number
RNMH-4
RIv-Nail 4lb. hammer installation tool from Conveyor Accessories features 14" fiberglass handle for use with rivet punches.

Spray Lubricant

For use with Riv-Nail Guide Blocks and APC-1.5 Belt Cutter.

NumberDescription
SL-8Individual Bottle
SL-8-1212-Pack

Belt and Rivet Gauge

A gauge to use in selection of proper fastener and rivet.

Number
BG-96
Riv-Nail Belt and Rivet Gauge installation tool from Conveyor Accessories is used to select proper fastener and rivet.

Guide Locator

Low Form Guide Locator

1/4" Gauge Rod - 3/4" high
Number
RNGL-1

High Form Guide Locator

7/16" gauge rod — 1" high
Number
RNGL-2

Pilot Nail Guide Replacement Strips

NumberDescription
RNGS-55-Pilot
RNGS-88-Pilot
Pilot nail guide replacement strips for Conveyor Accessories Riv-Nail installation tools

RNAT Replacement Parts

Number
RN 22A
RN 22A18
RN 24
RN 25
RN 716